Blaine, Minnesota
Experienced Metal Roofing in Blaine, MN
The open, largely treeless sand plain under Blaine, where nothing slows the wind between one plat and the next, is what makes the case for metal here. Gusts work at ridge caps, hip corners and the first courses of shingles until something lifts. A standing seam panel hides its fasteners inside the seam and gives that wind nothing to grab. Plain roof planes make it cheaper too.
Get your estimate today
Rated 5.0 from 217 Google reviews
- Licensed and insuredMinnesota exterior contractor
- 5.0 from 217 reviewsVerified on Google
- Storm and insurance workWe handle the claim with you
- Faith-based, locally ownedRefreshingly honest
On open ground the edge is the whole job
A first wave Blaine plat gives us long, uninterrupted planes: eave to ridge in one panel, no end laps, nothing to seal in the middle of a run. That is the least expensive metal roof anyone can build, and it is also the one that fails least. We tear off, look at the OSB and the nailing pattern, and replace anything soft before a single clip goes down. Then the edges get the attention, because on open ground the edge is the whole job. Rake trim, hemmed panel ends, closures at the ridge that shut out blowing snow. Skip any one of those and the wind finds it in the first hard fall. Homes with more architecture than that usually belong in a conversation about luxury roofing, where the profile is picked for the house first.
Metal Roofing in Blaine
What standing seam does on an open plat
No edge for wind to lift
Fasteners sit under the seam instead of out in the weather. There are no ridge caps to peel and no first course of shingles for a gust to get under.
Eave to ridge in one panel
Most Blaine plats have plain hip and gable planes, so panels run full length with no end laps. Fewer joints across the roof means fewer places for water to start.
Color that survives a treeless lot
Nothing shades these roofs. A coated steel finish holds its color through full summer sun far longer than asphalt granules do, which matters on a street where every roof is visible.
Permits handled on either county side
Blaine sits in both Anoka and Ramsey counties. We handle the paperwork and the inspection scheduling either way, so the address never becomes your problem.
Ridge closures made for blowing snow
Snow crosses these plats sideways with nothing to slow it. The ridge gets a closure that vents the attic without leaving driven snow a path into it.
Gutters sized for a faster roof
Water leaves steel faster than it leaves shingles. We check the gutter and drip edge before we finish, because an eave that handled asphalt runoff can overshoot with metal above it.
How we work on Blaine roofs
We price both roofs
Metal is not always the answer. We quote the standing seam and the asphalt beside it so you are comparing real numbers instead of a sales pitch.
Measured on the roof itself
Hip lengths, ridge runs and rake edges decide a metal quote. We get up there and measure them rather than pulling an aerial report and calling it a plan.
You see the panel first
We bring panel samples to the driveway and hold the profile against your siding and brick. Seam height and sheen change a lot between an overcast morning and full sun on a lot with nothing shading it.
We know where your plat sits
A first wave plat reaches the end of its shingles at once. We will tell you where your roof sits in that run, which is useful whether you buy now or in three years.
Trim and gutter color settled together
Panel, fascia, gutter and rake trim all show at once on a street where nothing blocks the view. We pick those colors as a set rather than ordering panel first and matching the rest to it afterward.
What people near Blaine say
The crew arrived early and spread tarps all around the house to capture every bit of debris. By 3:00 PM, my entire roof was completely finished.
Hazel JamesRoof replacement, Minneapolis, MN Orange Exteriors fixed a minor leak that involved replacing flashing and a few shingles blown off our roof. Timely, quality work. Great ideas to keep our roof going long term.
Jim ThomasStorm damage repair From sales to construction crew to upper management, they helped make an insurance battle a breeze. This is the best contractor interaction I have ever had.
Jim NormanRoof replacement
Metal roofing questions from Blaine
What people in Blaine ask us about this work. If yours is not covered, call and ask.
Does a metal roof make sense on a Blaine house built in the 1990s?
Often, yes, because the first wave of plats is reaching the end of its shingles now and the exposure here argues for steel. The deciding factor is the roof shape. Long, plain hip and gable planes make standing seam straightforward. A cut up roofline with several dormers pushes the cost up fast, and we will say so.
Can you put standing seam over the shingles on my Blaine house?
We would rather not. A layover hides the decking, and on these homes the sheathing is usually fine but the nailing sometimes is not, which is exactly what you want to know before clips go down. Tear-off also lets ice and water shield go in at the eaves and valleys, where a metal roof still needs it.
How does metal hold up to wind with no trees anywhere on the block?
Better than anything with an exposed edge. The clips are hidden in the seam and screwed into solid decking, so there is no tab or cap sitting out in the airflow. The failures we see on standing seam are almost always trim: a rake or a ridge closure that was face fastened instead of hemmed and locked.
Get the metal and asphalt numbers together
Tell us the street and we will walk the roof, measure the ridge and hip runs, and put a standing seam quote next to a shingle quote. Free either way.
Get Your Free Exterior Estimate
Tell us what is going on with your roof, siding, windows, or gutters. We will take a look and give you a straight answer, including when the answer is that you can wait.
- Phone(612) 600-8529
- Emailadmin@orange-exteriors.com
- Office6600 City West Pkwy Suite 375, Eden Prairie, MN 55344
- HoursOpen 24 hours, Sunday to Saturday
Request your estimate
Rated 5.0 from 217 Google reviews